Features of infrared emitters

The infrared radiator is composed of nickel-chromium alloy heating wire and silicone rubber high-temperature insulating cloth. It has superior physical properties, high strength, and can withstand repeated bending without affecting the heating life and performance. At the same time, the product can be made into various shapes according to customer needs, with strong plasticity. Very good flexibility, so that the infrared radiator can be in close contact with the object to be heated, and the heating effect is good. one. Product Usage

1) Silicone rubber heaters can be used in humid, non-explosive gas occasions, mixing heat and heat preservation of industrial equipment pipes, tanks, etc. (oil drum heaters), and can be directly wrapped on the surface of the heated object when used.

2) As freezing protection and auxiliary heating for air conditioner compressors, motors and other equipment.

3) As an auxiliary heating for medical equipment (such as blood analyzers, test tube heaters, health care corsets, body sculpting and slimming belts, etc.).

two. Features

1) Rapid heating, its thermal conductivity is 1W/c㎡. Due to its small heat capacity, it can be turned on or off quickly.

2) High thermal efficiency, in the case of boiling liquid, the temperature of the heating film itself is only tens of degrees higher than that of the liquid, saving energy 2-3 times compared with ordinary electric furnaces.

3) Water resistance, acid resistance, alkali resistance, high electrical insulation strength.

4) High mechanical strength, 100kg/cm2.

5) Small in size, the heating plate takes up almost no space during use.

6) Easy to use, because of its own insulation and no open flame, the process of heat preservation and heat insulation is greatly simplified.

7) The temperature range is wide, from -40°C to 200°C, which is beyond the reach of ordinary electrical appliances.

8) Long service life, under normal use conditions, it can be used continuously almost forever.

9) It can be made into any size, and the precise temperature control function can be assisted by a temperature controller.

three. Technical Parameters

1) Maximum temperature resistance of insulating materials: 250°C

2) Operating temperature range: -40~200℃

3) Power error: ±5%

4) Insulation resistance: ≥50 MΩ

5) Compressive strength: 1500v/5s

6) Withstand voltage: >5 KV

7) Mechanical strength: 100kg/cm2

Four. Precautions

1) The infrared radiator is a non-waterproof structure, so it should not be in contact with oil, water, or plastic particles during storage, use, and installation to prevent leakage.

2) Before installation, check whether the installation location is consistent with the specifications of the infrared radiator, and whether the operating voltage is consistent.

3) When installing, the electric heating plate must be closely attached to the heated body, and the surface of the heated body should be flat and complete without unevenness.

4) If the surface of the electric heating plate is found to have a burnt black color after use, it indicates that the heat generation and the heat dissipation of the heated body are unbalanced, and adjustments should be made in time to prevent burn-through.

5) It is forbidden to bend, drill or modify the finished product of the infrared radiator, otherwise it will damage the internal heating element, and even cause electric shock, leakage and other dangers.